Controlled by the Duet 2 WiFi, 32-Bit, a powerful 3D Printer controller made in the UK with top-quality components. 

The interface is a 7-inch touchscreen also made by Duet3D, which offers web access from both PC and mobile phones via WiFi, as well as USB and SD card.

To ensure the utmost precision Modix uses ball nut screws for Z axis and genuine Hiwin MGW12H guide rails for X and Y.

All belts are Gates GT2 9mm fiberglass reinforced belts.

These combine to produce position accuracy of :
X 5 Micron, Y 10 Micron,  Z 0.5 Micron

The print bed is a 6.35mm thick Alcoa Mic6 milled cast aluminum tooling plate to ensure a flat, even printing surface.

Heated by a 1600W dual zone AC heater.

PEI print surface for maximum material compatibility.

Made in the USA.

The E3D Volcano hotend & Titan extruder used for both primary and secondary hotends are the industry standard for high quality. This ensures consistent, reliable extrusion.

Gear ratio of 3:1 and 40mm NEMA 17 motor for high extrusion force.

1.75mm for compatibility with the widest range of materials.

0.4mm, 0.6mm, and 0.8mm Brass Volcano nozzles included.

Made in the UK.

Precision ball screws powered by a stepped-down belt gear allow for layer heights as small as 0.5 Microns.

This allows for print resolutions twice as fine as the standard desktop printer.

Professional shielded signal cables provide maximum reliability.

Made in Germany.