XTR Flexi Plate with Textured ULTEM PEI - Bambu Lab - 258 x 258

XTR Flexi Plate with Textured ULTEM PEI - Bambu Lab - 258 x 258

Our Textured PEI Flexi Plates in the XTR (or eXTReme version) start with our thicker 0.6mm high chromium spring steel to better resist the peel forces of edge-to-edge prints or high shrinkage filaments. They are then electrostatically powder painted with authentic ULTEM™ brand PEI from Sabic, and kiln-baked for exceptional durability. The Flexi Plate has a double-sided textured PEI coating leaving a pronounced finish on the bottom of your print.

Compatible with the Wham Bam Magnetic Base (not included), this Flexi Plate is ideal for a variety of filaments, including PLA, TPU, PETG, and ABS. For additional adhesion with challenging materials like Nylon, use purple glue sticks or Magigoo, which wash off easily.

Compatibility

Fits:

• Bambu Lab A1
• Bambu Lab P1P
• Bambu Lab P1PS
• Bambu Lab X1
• Bambu Lab X1 Carbon (or X1C)
• Bambu Lab X1E

May fit:

• Elegoo Centauri Carbon*
• TwoTrees SK1**

*The Flexi Plate fits the X (width) of the plate perfectly, but is about 5mm short of the Y. When centered, it would cover the 256 build volume.

**Exact fit but without alignment tab.

Contents & Tech Info

Includes:

• 1 XTR Powder Painted Ultem™ PEI Flexi Plate
• 5 Textured PEI Plate Aruco QR stickers

Dimensions:

• 258 x 258 mm
• Flexi Plate 0.6 mm
• ULTEM™ PEI Build Surface 0.12 mm, on each side

Sensor Compatibility:

• Eddy current mesh
• Optical sensors
• Touch sensors
• Inductive
• Capacitive
• Cartographer

Note: You should already have a magnet or clips installed on your printer, as this is needed to use a Flexi Plate.

Level after install

If your machine has automatic bed leveling, run the leveling process and set your gap such that the first layer is well squished. For more details on achieving the right first layer squish, refer to this bed leveling guide.

If your printer uses manual leveling, follow the same guide for instructions on the leveling process.

Use & Maintenance

Cleaning Before & After prints

• After every print, we suggest wiping with isopropyl alcohol and a fresh paper towel. If you have small bits, such as purge lines, stuck to the surface you can try with a steel spatula with corners rounded to carefully remove these. Do not use Acetone as this will damage the surface.

Longterm Contaminants cleaning:

• Should the PEI ever lose its grip, you may also try common dish detergent or vinegar and clean with water as these help break fats added to filaments with effects. You can also lightly pass over the plate with 600 grit wet dry sandpaper to revitalize, then clean with IPA and a fresh paper towel.

STL Download

Full support info can be found on our support page.