Takoto HE50 "Monster" Super High Flow - Bare Hotend

Takoto HE50 "Monster" Super High Flow Hotend
w/ Bondtech BMG-M/LGX Mount - Bare Hotend Kit

The Takoto HE50 hotend is a longer variant of the Takoto HE20 hotend. It was developed to take the already high flow rates of the HE20 and make them even higher by extending the melt zone by 3 times. 

This is the Bare Hotend only. It includes the hotend with a silicone sock and the custom dual 60W heaters, but no other electronics or nozzles. The Takoto HE50 is also available in as complete hotend so you'll have everything you need to make the most of this hotend. Find the Complete hotend HERE.

Key Features

• All metal (tested to >320°C)
• Dual vertical heater cartridges (standard Ø6.0 x 20mm, any wattage that your machine can support), clamped in for good thermal transfer
• Standard Ø3.0 x 15mm temp-sensor (thermistor or PT100/1000) clamped between the heaters & the nozzle for accurate sensing
• Standard E3D SuperVolcano nozzle, which are readily available in various metals & work well
• Very rigid structure via 3 titanium hollow pillar mounts, because crashes happen and threaded heat-breaks can bend, tear out, or break
• The heat is retained to the melt zone by the titanium feed tube & copper heat sink, significantly limiting heat-soak to the filament in the feed mechanism
• Very well cooled via modular fan options, and design protected for future liquid cooling
• Thermally protected with a high-temperature silicon sock to minimize heat loss (increase efficiency) & for safety
• Independently proven to flow >30mm3/s consistently, continuously, repeatably (PLA+ @ 215C, 0.8 nozzle, 0.4 layer)
• Designed for mounting to Bondtech BMG-M; Bondtech LGX; Titan Aero; Hemera; Raise 3D N1; ...  with designs for alternative mounting options in future
• Extra processing capacity - independently proven to consistently & continuously deliver >55mm3/sec (PLA+ @ 215C, 1.0 nozzle, 0.5 layer) .This dual-cartridge Hotend chews through filament at an astonishing rate.
• It is strong! The Body is held rigid by the same 3 titanium pillars that have proven near indestructible on the HE20, and it is interchangeable with the HE20. There is no chance of shearing off a weak heat-break with this Monster.